aluminum honeycomb panel

(1)Brief introduction
The idea of manufacture the aluminum honeycomb  panel is from the honeybee, In the natural. The honeybee uses the least beeswax in building it's commodious,steady and firm honeycomb. We compose aluminum honeycomb-core and two aluminum sheets that composite on each side of the core. With special glue and produced light but strong aluminum honeycomb  panel, We coated on the outside surface of the sheets.
Since the air between the sheets is separated to holes sealed, the propagation of heat and sound wave are greatly restricted.
So the panel is good at heat preservation and sound insulation.
In the past time the aluminium honeycomb  panel is just used in the field of aviation,  in recent years with the development of economy. It is used in civil field step by step for example in the decoration of building, vehicle and ship's wallboard or partition and so on.
The aluminium honeycomb  panel of our company is mainly used in the outside and indoor decoration of building, as the partition or wallboard etc.

(2)Classify
According to the lacquer of Coating:
A. PVDF
B. Polyester

(3)Specification
A. General size          unit: mm

   Length1000-5000
   Width1220-1500
   Thickness6.0, 10.0, 15.0, 20.0, 25.0

B. If you need special specification, please tell us.

C. The specification expression of the panel
Length* Width*face sheet coating code and thickness (type)
Example:
Length: 2440mm, width: 1220mm,thickness:6.0mm,PVDF(FC)coating
Code: 2440*1220*F6.0
Length: 3200mm, width: 1250mm,thickness: 25.0mm, PET coating
Code: 3200*1250*P25.0