ACP processing
PE extruder, membrane head, three roll presser, laminating, trimming, uncoiling for back al coil, back al compose, 8 roll compose, 4 roll cold, cold stand, laminating protecting, two roll draw, cutting as lines, finished product transmission

Composition of ACPL
Plastic extruder, PE extruder, DC motor, 185kW or above; screw bar D150-180MM, output ≥700kg/hr

Dryer for raw material filler mode volume in 400kg, electrical heating 20kW
Automatically material vacuum feeder, Motor 1HP, transmission ability: 400kg/H
Type T mould for extruding, Width of mould lip: 1650-1810mm
Electricity operation panel
Three rolls presser to flat
Individually driven system for three rolls, 1.5kw, single run, non-stop run
Roll temperature controlling system, 30kw, temperature control on three units in hot water circulation
Adjuster for roll distance, Available for auto or manually adjusting
Laminating unit
Rubber presser roll, Laminating compose
Uncoiling stand, up and bottom setting, manually tension controlling
Trimmer stand
Stand of supporting roll
PE transmission plate
Material feeder, Hydraulic for tighten, Al coil pinching
Magnetic brake, Adjust tension manually
Material piling platform, Al coil (upper side) piling platform, Installing on site
Laminating unit of back aluminium plate
Steel, rubber couple rolls, Pre composing
Driven system, motor driven with power of 2.2kW
Roll temperature controller, Hot oil circulate heating, temperature controlling automatically

Four-roll cold mould units
Steel roll unit, Cold pressing and molding
Roll temperature, Circulation cold water for cooling
Transmission stand, Stainless steel roll, Product cold transmission
Protect film coating and trimming
Rubber roll units, protecting membrane stick
Trimming units, Sliding cutting and trimming
Drawer, Driven motor 3kW
Auto-fixed length cutter
Cutter stand
Following motor, synchronously speed with laminating
Hydraulic unit, Lubro pump motor 2.2kW..