PLC ortemperature gauge control.
* High extrusion capacity, low melt temperature.
* Special screw design insure the high-efficiency and high yield.
* Bevel gear design of high hardness and low noise brings dependableperformance with long service life.
*Adopt direct current speed regulation design for the standard, also thefrequency variable speed adjusting and the electromagnetism speed adjust may bechosen.
* According to the different material extrusion choosing the differentextrusion machine.
* Small type single screw extruder applies to co-extrusion the marking line.

PVC pipe formingdiameter:

* entrywith cooling device forming diameter sets, applicable to extrude pipe at highspeed.

*Mold in the reduction of wear and to improvethe efficiency of thermal conductivity between the die struck a good balance.

Vacuum forming diameter water tank
* Use stainless steel to produce the water tank

* Thehigh power water pump and special design of spray head bring effective spraycooling.

* Indiameter set with dense and stronger section of the spray head layout.

* Take the by-pass pipe filtering units improved equipment maintenance andreduce and maintain workload.